Ryobi RBV26B User Manual page 17

Deutsch (Übersetzung der originalen Anleitungen)
VACUUM HANDLE
comfortably.
VACUUM TUBES
cross-head screwdriver.
ASSEMBLY
PACKING LIST
Upper blower tube
Lower blower tube
Adaptor installed in vacuum bag
Upper vacuum tube
Lower vacuum tube
Lubricating oil
Operator's manual
Figure sheet
UNPACKING
Carefully remove the product and any accessories
from the box. Make sure that all items listed in the
packing list are included.
WARNING:
Do not use this product if any parts on the Packing
List are already assembled to your product when
you unpack it. Parts on this list are not assembled
to the product by the manufacturer and require
customer installation. Use of a product that may
have been improperly assembled could result in
Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
Do not discard the packing material until you have
care fully inspected and satisfactorily operated the
product.
ASSEMBLING THE BLOWER TUBES
See Figure 2.
Close the vacuum inlet cover securely. Make sure the
metal contact on the inlet cover is inserted into the
positive switch.
Align the raised tabs on the blower housing outlet to
the slots at the upper tube; slide and tighten securely
by twisting; press slider plate into the slot of the
positive switch to make sure the switch is engaged
and ready to operate.
English (Original instructions)
INSTALLING THE VACUUM BAG
See Figure 3-4.
INSTALLING THE VACUUM TUBES
See Figure 5 - 6.
To install the vacuum tubes:
To remove the vacuum tubes:
15 15
Connect the lower and upper tubes together.
Connect the nozzle.
positive switch, then rotate the tubes to remove them
from the blower housing outlet.
Unzip the vacuum bag and place the adaptor inside
as shown. Push the vacuum bag adaptor through the
end of the adaptor will remain in the vacuum bag when
installed properly.
Align the raised slots on the vacuum bag adaptor with
the raised locking tabs on the blower housing outlet;
into place, press the metal contact into the positive
switch slot to make sure the switch is engaged and
ready to operate.
Rotate the vacuum bag until the shoulder strap is
upright.
Make sure the vacuum bag is zipped and closed
before starting the unit.
WARNING:
Rotating impeller blades can cause severe
impeller blades have stopped rotating before
the vacuum tubes while they are installed on the
unit.
Secure the upper and lower vacuum tubes together
by aligning the raised locking tabs with the matching
become one tube assembly after inserting them
together.
Depress door tab using a flathead screwdriver to open
the vacuum inlet cover.
Align tabs on housing with the tube assembly.
to the blower housing. Make sure the metal contact on
the vacuum tube is inserted into the positive switch.
Loosen screws of the upper vacuum tube by turning
counterclockwise.
Remove the vacuum tube assembly from the blower
housing.