Operation - Ryobi RBV26B User Manual

Deutsch (Übersetzung der originalen Anleitungen)
Close the vacuum inlet cover securely. Make sure the
metal contact on the inlet cover is inserted into the
positive switch.

OPERATION

NOTE:
the metal contacts are inserted into the positive switches.
When running the unit in blower mode (Fig. 8), the metal
contact on the blower tube and inlet cover must be inserted
into their respective positive switches. When running the
unit in vacuum mode (Fig. 11), the metal contact on the
adapter tube and the vacuum tube must be inserted into
their respective positive switches.
WARNING:
Do not allow familiarity with this product to make
you careless. Remember that a careless fraction
WARNING:
Do not operate the machine near open windows.
WARNING:
Always wear eye protection with side shields
hearing protection. Failure to do so could result
APPLICATIONS
You may use this product for the purposes listed below:
Clearing leaves and other debris from your lawn.
pine needles.
Vacuuming leaves from your lawn.
MIXING THE FUEL
a 50:1 ratio.
NOTE: Mix 2% lubricant into the petrol. Use synthetic
2-stroke lubricant only.
Use a clean container that is approved for use with
petrol.
Mix the 2-cycle engine oil with unleaded petrol in the
container according to the instructions on the oil pack-
age.
NOTE:
petrol intended for automotive use with an octane rating
2-cycle outboard oil.
NOTE: Most fuel mixture will stay fresh up to 30 days. DO
English (Original instructions)
2-CYCLE FUEL / OIL MIX (50:1)
FILLING THE TANK
OXYGENATED FUELS
Fuel system damage or performance problems resulting
from the use of an oxygenated fuel containing a
percentage of oxygenates more than that stated previ-
Petrol containing up to 10% ethanol by volume (commonly
referred to as E10) or 15% ethanol by volume (commonly
referred to as E15) are acceptable.
Do not use E85 fuel. It will void your warranty.
STARTING AND STOPPING
See Figure 7.
NOTE: It is normal for smoke to be emitted from a new
16 16
PETROL
1 gallon (US)
1 liter
WARNING:
others. Always shut off engine before fueling.
hot engine. Move at least 9m away from the
refueling site before starting engine. Do not
sparks. Failure to safely handle fuel could result
Clean the surface around the fuel cap to prevent con-
tamination.
Loosen the fuel cap slowly by turning counterclock-
wise.
Pour the fuel mixture carefully into the tank.
Clean and inspect the fuel cap gasket before replacing
the fuel cap.
Replace the fuel cap and tighten it by turning it clock-
wise.
Wipe any spilled fuel from the product.
Move at least 9m away from the refueling area before
start ing the product.
WARNING:
hazard and must be replaced immediately. If
using the product. Failure to do so could result
OIL
2.6 oz.
20 cc (20 ml)