Status Monitor; Displaying The Condition Of The Projector - Dukane 8970 User Manual

Status Monitor

Status Monitor
The Status Monitor is the sub LCD in the rear panel of
8971, 8973W and 8975WU. The Status
Monitor displays the present condition of the projector
including errors, setup information and error history.

Displaying the condition of the projector

If no buttons have been operated, the Status Monitor displays as below depending
on the condition of the projector.
NOTE
• The Status Monitor displays nothing while the projector is in standby
mode if the STANDBY MODE item of SETUP menu is set to SAVING (54).
• When INSTALLATION in the SETUP menu is set to FRONT / CEILING or REAR /
CEILING, the contents on the Status Monitor are displayed upside down (53).
 In a normal state
The Status Monitor displays the condition of the
projector in three lines.
: Displays the condition of the projector.
1st line
While the lamp is on, the selected port is
displayed.
Displayed conditions are as below;
STANDBY: The projector is in standby mode.
WARM UP: The projector is warming up.
SEARCHING: The projector is searching an input signal.
COOL DOWN: The projector is cooling down.
: Displays the condition of the detected input signal while the lamp
2nd line
is on. Otherwise, displays the serial number of the projector.
Displayed conditions are as below;
SYNC OUT: Detected input signal is out of specified range.
NO SIGNAL: There is no input signal.
CONNECTED: The projector has connected to the network or the computer
and some image is transferred to the projector while the LAN or USB TYPE
B port is selected.
HOLD: The projector has connected to the network but no image is transferred
while the LAN port is selected.
NOT CONNECTED: The projector is not connected to the network or the
computer while the LAN or USB TYPE B port is selected.
(continued on next page)
20
<Only for 8971, 8973W and 8975WU>
Status Monitor
S T A N D B Y
# 1 2 3 4 5 6 7 8
example
9 0 A B
2 3 ° C