Sony MHC-DX8 Operating Instructions Manual page 6

Step 1: Hooking up the system
(continued)
6
Set VOLTAGE SELECTOR to the
position of your local power line
voltage.
Set the same voltage range for the
satellite amplifier and main unit.
VOLTAGE
120V
7
Connect the power cord to a wall
outlet.
The demonstration appears in the
display. When you press ?/1, the
system turns on and the demonstration
automatically ends.
If the supplied adaptor on the plug does
not fit your wall outlet, detach it from
the plug (only for the model equipped
with an adaptor).
To disconnect the system
Make sure you disconnect the AC power cord
from the wall outlet before you disconnect
the system.
To connect optional components
See page 37.
To deactivate the demonstration
When you set the time (see "Step 3: Setting
the time"), the demonstration is deactivated.
To activate/deactivate the demonstration
again, press DISPLAY while the system is
off.
6
SELECTOR
230 - 240V
220V
To attach the front and satellite
speaker pads
Attach the supplied front and satellite
speaker pads to the bottom of the speakers to
stabilize the speakers and prevent them from
slipping.
Inserting two size AA (R6)
batteries into the remote
Tip
With normal use, the batteries should last for about
six months. When the remote no longer operates
the system, replace both batteries with new ones.
Note
If you do not use the remote for a long period of
time, remove the batteries to avoid possible damage
from battery leakage.
When carrying this system
Do the following to protect the CD
mechanism.
1 Make sure that all discs are removed from
the unit.
2 Hold down CD and then press ?/1 so that
"LOCK" appears in the display.
3 Unplug the AC power cord.
e
E
E
e