Advertisement
6.25 Address 31 - Open/Close Duress Report
• Open: This report is sent when the system has been
disarmed. In Contact ID, SIA or 4/9 formats, the user
number for the person who disarmed the system will
be sent with this report. To send the user number
along with an Open Report in other formats, program
the extended digit of the report as F ([*] [5]). The Open
Report will only be sent if a Close Report was sent
previously.
• Close: This report is sent when the system has been
armed. In Contact ID, SIA or 4/9 formats, the user
number for the person who armed the system will be
sent with this report. To send the user number along
with a Close Report in other formats, program the
extended digit of the report as F ([*] [5]).
• Duress: This report is sent when the system is
disarmed using a duress code. The user number will
not be sent along with this report.
• Partial Close: This report is sent when the system is
armed partially, or force armed.
• First Open After Alarm: This report is sent when the
system is disarmed after an alarm has occurred. It will
also be sent if the system is already disarmed and a
user number is entered to silence a 24-hour or fire
zone.
DS7060-AUS Reference Guide
Copyright © 2001 Detection Systems, Inc.
6.26 Address 32 - Battery, AC Report
• Low Battery Report: This report is sent when a low
battery condition occurs.
• Low Battery Restoral Report: This report is sent
when a low battery condition restores.
• AC Failure Report: This report is sent after an AC
failure condition occurs. AC failure reports will only be
sent along with other reports if Address 50 is set to
"000." Otherwise reports will be sent after the delay set
in Address 50.
• AC Failure Restoral Report: This report is only sent
along with other reports if Address 50 is set to "000."
Otherwise reports will be sent after the delay set in
Address 50.
6.27 Address 33 - Programming Report
• Remote Programming Successful: This report is
sent after a Remote Programming session, if the
session was terminated properly.
• Remote Programming Unsuccessful: This report is
sent after a Remote Programming session, if an error
occurs or session doesn't terminate properly.
• Local Programming Successful: This report is sent
when local programmer's mode is exited and no error
is associated with the programming.
Page 17
Advertisement
