Mounting Bracket - Audi TT 2007 Repair Manual

Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
– Attach mounting clip -2- to clutch master cylinder actuator rod
-1-.
– Press mounting clip in until it engages audibly in the clutch
pedal opening.
– Place over-center spring -2- in the bearing bracket from above
and hold the end of the spring in the installation position with
the -T10178- .
• The over-center spring mounting cup -arrow- must be vertical.
– Insert clutch pedal pressure tab -A- in over-center spring
mounting cup -arrow-.
– Press the clutch pedal up and forward against the force of the
over-center spring, slide the bolt through and tighten the self-
locking nut.
Note
The clutch pedal can be pushed against the spring force easier
when carefully pulling back on the bottom of the clutch pedal, piv‐
oting the top to the installed position.
– Install the impact bolster
– Install the left front footwell vent. Refer to ⇒ Heating, Ventila‐
tion and Air Conditioning; Rep. Gr. 87 ; Removal and Instal‐
lation .
– Install the driver side storage compartment. Refer to ⇒ Body
Interior; Rep. Gr. 68 ; Removal and Installation .
4.4

Mounting Bracket

Special tools and workshop equipment required
♦ Hose Clamps Up to 25 mm Diameter -3094-
♦ Hose Clip Pliers -VAS 6340-
34
Rep. Gr.30 - Clutch
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ page 18 .