Pedal Assembly, Master Cylinder Assembly Overview - Audi TT 2007 Repair Manual

2.2

Pedal Assembly, Master Cylinder Assembly Overview

Note
Grease bearing areas and slide surfaces with grease -G 000 450 02- .
1 - Bulkhead
❑ With mount for mount‐
ing bracket
2 - Gasket
❑ Replace
❑ Between the bracket
and bulkhead
❑ Self-adhesive
❑ Glue on mounting
bracket
3 - Bracket
❑ For clutch pedal
❑ Removing and instal‐
ling, refer to
⇒ "4.4 Mounting Brack‐
et", page 34
4 - Bolt
5 - Over-Center Spring
❑ Removing and instal‐
ling, refer to
⇒ "4.2 Over-Center
Spring", page 30
6 - Bushing
7 - Pivot Pin
8 - Clutch Pedal
❑ Removing and instal‐
ling, refer to
⇒ "4.3 Clutch Pedal",
page 32
❑ In the case of replace‐
ment, recut the clutch
pedal cap ⇒ page 18
9 - Mounting Clip
❑ For the clutch master cylinder actuator rod
10 - Oil Seal
❑ Replace
❑ Between the clutch master cylinder and bearing bracket
11 - Clutch Master Cylinder
❑ Removing and installing, refer to
12 - Clutch Position Sensor -G476-
❑ Removing and installing, refer to
❑ Check in guided fault finding ⇒ Vehicle diagnosis, testing and information system VAS 5051
13 - Retaining Clip
❑ To remove and install the hose/line assembly, pull the clip out to the stop
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ "4.6 Master Cylinder", page 37
⇒ "4.5 Clutch Position Sensor", page 36
Manual Transmission - Edition 10.2009
2. Description and Operation
Audi TT 2007 ➤
17