Removal And Installation; Hose/Line Assembly Or Plastic Line - Audi TT 2007 Repair Manual

4

Removal and Installation

⇒ "4.1 Hose/Line Assembly or Plastic Line", page 29
⇒ "4.2 Over-Center Spring", page 30
⇒ "4.3 Clutch Pedal", page 32
⇒ "4.4 Mounting Bracket", page 34
⇒ "4.5 Clutch Position Sensor", page 36
⇒ "4.6 Master Cylinder", page 37
⇒ "4.7 Slave Cylinder with Release Bearing", page 39
⇒ "4.8 Sachs Clutch", page 40
⇒ "4.9 LuK Clutch", page 42
4.1

Hose/Line Assembly or Plastic Line

Special tools and workshop equipment required
♦ Hose Clamps Up to 25 mm Diameter. -3094-
Removing
– Completely remove the air filter housing. Refer to ⇒ Fuel In‐
jection and Ignition; Rep. Gr. 24 ; Removal and Installation .
– Clamp off the return hose to the clutch master cylinder with a
-3094- .
Note
While performing the following work, make sure that no brake
♦
fluid comes into contact with longitudinal member or with
transmission. If this happens, these areas must be cleaned
thoroughly.
Collect any leaking brake fluid with a cloth.
♦
– For removal, use a screwdriver to release securing clip -3- on
the clutch master cylinder.
– Remove hose/line assembly -1- or plastic line with O-ring -2-
and detach from the bracket.
Caution
Do not operate the clutch pedal when the hose/line assembly
or plastic line is removed.
Note
Collect any leaking brake fluid with a cloth.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Manual Transmission - Edition 10.2009
4. Removal and Installation
Audi TT 2007 ➤
29