AT&T E1812B User Manual page 37

1.
CLOCK.
The system will announce
the current clock setting,
then announces "To set the
clock, press CLOCK."
2.
CLOCK.
The system will announce
the current day setting, then
announces "To change the day,
SKIP or
press
to change the hour, press
CLOCK."
SKIP or
3.
REPEAT
until the system announces
the correct day, then press
CLOCK.
SKIP or
4.
REPEAT
until the system announces
the correct hour, then press
CLOCK.
SKIP or
5.
REPEAT
until the system announc-
es the correct minute, then
press CLOCK.
SKIP or
6.
REPEAT
until the system announc-
es the correct year, then
press CLOCK. The system
announces the current clock
setting.
Answering system operation
Day & time announcements
To set day and time
Before playing each message, the answering sys-
tem announces the day and time when the mes-
sage was received.
Before using the answering system, follow the
steps on the left of this page to set the day, time
and year, so that messages are dated correctly.
If the clock is not set, before new messages are
recorded, the system will announce "Time and day
not set" before each message is played back.
The system uses voice prompts to guide you. Each
time you press
minute or year increases or decreases by one.
REPEAT ,
When you hear the correct setting, press CLOCK
To check day and time
You can press CLOCK at any time to hear the cur-
rent day and time without changing it.
NOTES:
1. You can press and hold
decrease the minutes or years by ten.
information. After you set the time once, it will thereafter
The time will be set automatically only if you subscribe to
(page 27).
SKIP or
SKIP or
34
REPEAT , the day, hour,
REPEAT to increase or