Sym RS-50 Service Manual page 71

7. "V" TYPE BELT DRIVE SYSTEM/KICK-STARTER
Clutch Block Replacement
Remove clip and washer, and then remove clutch
weight and spring from drive plate.
Caution
Some of models are equipped with one
mounting plate instead of 3 snap clips.
Check if spring is damage or insufficient elasticity.
Check if shock absorption rubber is damage or
deformation. Replace it if necessary.
Apply with grease onto lock pins.
Install new clutch weight onto lock pin and then
push to specific location.
Apply with grease onto lock pins. But, the clutch
weight should not be greased. If so, replace it.
Caution
Grease or lubricant will damage the clutch
weight and affect the weight's connection
capacity.
Install the spring into groove with pliers.
7-12
This chapter Contents
Clutch weight
Shock absorption
rubber
Shock absorption rubber
Spring
Clutch block
Spring
Drive plate
Snap clip