Advertisement
Trouble Shooting
Should your DVD player develop a problem, please check below before requesting
service:
Symptom
Check and Action
No power
Make sure the unit has been powered on manually.
Check if the power cord has been properly connected to the power outlet.
Make sure the battery pack is fully charged.
Does not play No disc, load a disc.
Disc has been loaded upside down. Place the disc with the label side up.
Disc's rating level is higher than the player's setting.
Disc is incorrect type for the player.
Disc is damaged or dirty. Clean the disc or try another one.
Moisture may be condensed inside the player. Remove the disc and
leave the unit power on for one or two hours.
No Picture
Check if the TV set has been powered on. Use TV remote to select AV
signal for DVD rather than broadcast.
Check if the system connection is proper and secure.
Check if the connection cables are damaged.
Clean the disc.
Picture noisy/ Disc is damaged or dirty. Clean the disc or try another one.
distorted
Reset the color system of the TV set.
Make sure the DVD player is not connected through a VCR, cable or
satellite dish.
No sound or
Check if the TV and amplifier have been switched on and correctly set.
sound output
Check if the FV and amplifier system connections are secured.
not complete
Press AUDIO button to select other audio tracks output of disc.
Check if the MUTE function of the TV or amplifier has been activated.
There will be no sound output during REVERSE PLAY/PAUSE/SLOW
and SEARCH.
Remote
Make sure the POWER button on the unit has been turned on manually.
does not
Remove the obstacles between the remote control and the player.
work
Point the remote control towards the remote sensor on the player.
Check if the batteries of the remote control have been loaded with
correct polarities.
Replace the batteries of the remote control.
Malfunction
Should the player develop a malfunction, unplug the player for 30
minutes. After that, power on the player and the restore function should
reset the player.
17
Specifications:
Power Supply
DC 9V/2A(AC adapter Terminal)
Power consumption
7.5w typical
Singnal System
NTSC/PAL
Video otput
1+/-0.2V(p-p),75 Ohm,Negative Sync., 3.5mm mini jack x 1
Audio output
1.5Vrms (1KHz,odb), 3.5mm mini jack x 1
Earphone terminal
3.5mm stereo mini jack x 1
Signal/Noise ratio (autio) 90 dB typical
Dynamic range(audio)
90dB typical
Panel size
3.5 inch (4:3)
Resoution
480(W)x234(H) dot
Laser
Wavelength 650 nm
Operating conditions
Temperature: 0 c t o 3 5 c . . Operation status: Horizontal
Dimensions
Weight
The specs are only for your reference; any change to the design and specifications will not
be advised.
0
0
18
Advertisement
