Trouble Shooting - Coby DVD-218 User Manual

Should your DVD player develop a problem, please check below before
requesting service:
Symptom
No Power
Does not play
No Picture
Picture
noise / distorted
Picture not full
screen
Problem
message display
on screen
Malfunction
Check and Action
Check if the power cord has been properly connected to the power outlet.
Check if the main power has been switched on.
No disc, load a disc.
Disc has been loaded upside down. Place the disc with the label side up.
Disc's region code does not match to the player.
Disc's rating level is higher than the player's rating level setting
Disc is not correct type for the player.
Disc is damaged or dirty, clean the disc or try another disc.
Moisture may be condensed inside the player. Remove the disc and
leave the unit power on for one or two hours.
Check if the TV set has power on, use TV remote to select A/V signal for
DVD rather than broadcast.
Check if the system connection is proper and secure.
Check if the connection cables are damaged.
Clean the disc.
Please press OPEN button,then press PROGRAM and ZOOM button to
return factory default status.
Reset the color system of the DVD by pressing the NTSC/PAL button.
The DVD should be connected directly to the TV set, or use a R F modulator.
WRONG REGIONAL DISC; Disc region code not match to the player
WRONG PASSWORD The player refuses to play disc with a rating level higher
than the player s rating level setting
Select the screen format from the player's SETUP MENU,
see "SETUP MENU" of this manual.
Select the screen format from DVD disc menu.
Following message will display when there is a problem with the loaded disc:
WRONG REGIONAL DISC
"
WRONG PASSWORD
"
level higher than the player's rating level setting.
WRONG DISC The player is equipped with automatic disc
" " :
quality detection software. When the player detects a problem disc or a
damaged disc, the player may keep playing the disc at lower quality or
stop playing, depending on the damage level of the disc.
Press and hold the standby button (if any) for about 5 second to power off.
Should the player develop a malfunction, unplug the player for
30 minutes. After 30 minutes, power on the player and the restore
function should reset the player.
's
's
Disc's region code dose not match to the player.
" :
The player refuse to play a disc with rating
" :
18

TROUBLE SHOOTING