Technical Data; Installation - IKEA LIVSLAGA User Manual

ENGLISH
Technical data
Product Dimensions
Width (mm)
Height (mm)
Length (mm)
Voltage (V)
The technical information are situated in the
rating plate on the bottom side of the
appliance.
Note: A duplicate Data Plate provided with the
appliances should be affixed adjacent to the
appliance nearby on a cabinet or area where it
is easily accessible for reference.
Before installing the hotplate consider the location
of the gas supply and routing the gas line.

Installation

After unpacking the hob, make sure that it
has not been damaged during transport. In
the event of problems, contact the dealer or
your nearest After-sales Service.
Technical information for the installer
- This product can be embedded in a
worktop 20 to 50 mm thick.
- If there is no oven beneath the hob,
insert a separator panel that has a
surface at least equal to the opening
580
40
510
220 - 240
ELECTRICAL
CONNECTION POINT
GAS CONNECTION
POINT
in the work surface. This panel must be
positioned in no case less than 20 mm
from the bottom of the hob.
- Before installation, make sure that:
- the local gas delivery conditions (nature
and pressure) are compatible with the
settings of the hob (see the rating plate
and injector table);
- the outer surfaces of the furniture or
appliances adjacent to the hob are heat
resistant according to local regulations;
12