This section contains the following PC Keyboard Wedge communication
parameters in the order listed:
Keyboard Wedge Communication Parameters
•
Interface Selection
•
Connect to Laptop
•
Caps lock Settings
•
Country modes
•
Intercharacter Delay
Go to the sections titled Symbology Selection and General Features in the
back of this programming guide if you want to change any other settings.
If the transmission parameters are configured such that a label
results in no actual data to send, the label will be accepted, beeped,
and no data transmitted.
PC Keyboard Wedge Interface Selection
The scanner supports ten
below defines the different interface selections.
I/F Type
A
PC/XT w/Alternate Key Encoding
B
AT, PS/2 25-286, 30-286, 50, 50Z, 60, 70, 80, 90 & 95 w/Alternate Key Encoding
C
PS/2 25 and 30 w/Alternate Key Encoding
D
PC/XT w/Standard Key Encoding
E
AT, PS/2 25-286, 30-286, 50, 50Z, 60, 70, 80, 90 & 95 w/Standard Key Encoding
F
PS/2 25 and 30 w/Standard Key Encoding
G
IBM 3xxx w/122 keyboard
H
IBM 3xxx w/102 keyboard
I
PS/55 5530T w/104 keyboard
J
NEC 9801
We recommend that you disconnect power before plugging/
unplugging cables to avoid any possibility of equipment damage.
24
NOTE
1
PC Keyboard Wedge interfaces. The table
PCs Supported
NOTE
QuickScan 6000/6000 Plus Programming Guide
(QuickScan 6000 Plus ONLY)
(QuickScan 6000 Plus ONLY)
(QuickScan 6000 Plus ONLY)
(QuickScan 6000 Plus ONLY)