Motorola DS6708 Product Reference Manual page 81

The digital scanner also interfaces with other USB hosts which support USB Human Interface Devices (HID).
To set up the digital scanner:
NOTE Interface cables vary depending on configuration. The connectors illustrated in
are examples only. The connectors may be different than those illustrated, but the steps to connect the
scanner are the same.
Connect the modular connector of the USB interface cable to the cable interface port on the digital scanner
1.
(see Installing the Interface Cable on page
Plug the series A connector in the USB host or hub, or plug the Plus Power connector in an available port
2.
of the IBM SurePOS terminal.
Select the USB device type by scanning the appropriate bar code from
3.
On first installation when using Windows, the software prompts to select or install the Human Interface
4.
Device driver. To install this driver, provided by Windows, click Next through all the choices and click
Finished on the last choice. The digital scanner powers up during this installation.
To modify any other parameter options, scan the appropriate bar codes in this chapter.
5.
If problems occur with the system, see
1-3).
Troubleshooting on page
USB Interface
Figure
USB Device Type on page
3-2.
6 - 3
6-1and Figure 6-2
6-5.