IBM xSeries 150 User Reference Manual page 93

Table 12. POST error messages
POST message
00180400 A PCI adapter has requested a memory address that is not available.
Action:
00180500 A PCI adapter ROM error occurred.
Action:
If you cannot isolate and correct the problem, call for service.
00180600 A PCI-to-PCI bridge error occurred. More than one PCI bus tried to access memory below 1 MB.
Action:
If you cannot isolate and correct the problem, call for service.
00180700 xxxxyyyy Planar PCI device does not respond. (Where xxxx is the PCI vendor ID and yyyy is the
PCI device ID.)
Action:
00180800 An unsupported PCI device is installed.
Action:
If the problem persists, call for service.
00181000 PCI error.
Action:
If the problem persists, call for service.
01295085 The ECC checking hardware test failed.
Action:
01298001 No update data is available for processor 1.
Action:
01298002 No update data is available for processor 2.
Action:
01298101 The update data for processor 1 is incorrect.
Action:
01298102 The update data for processor 2 is incorrect.
Action:
If all memory addresses are being used, you might need to remove an adapter to
make memory address space available to the PCI adapter. Disabling the adapter
BIOS on the adapter might correct the error. Refer to the documentation provided
with the adapter.
Remove the PCI adapters. If you can start the server without the adapters, reinstall
each adapter one at a time and retest after each is reinstalled. When an adapter fails,
replace it.
Remove the PCI adapter that has the PCI bridge. If you can start the server without
the adapter, reinstall and retest the adapter. If the adapter fails, replace it.
Call for service.
Remove the PCI adapters. If you can start the server without the adapters, reinstall
each adapter one at a time and retest after each is reinstalled. When an adapter fails,
replace it.
Remove the PCI adapters. If you can start the server without the adapters, reinstall
each adapter one at a time and retest after each is reinstalled. When an adapter fails,
replace it.
Call for service.
Update the system BIOS to a level that supports the microprocessors installed in the
server.
Update the system BIOS to a level that supports the microprocessors installed in the
server.
Update the system BIOS to a level that supports the microprocessors installed in the
server.
Update the system BIOS to a level that supports the microprocessors installed in the
server.
Description
Chapter 4. Solving Problems
81