IBM xSeries 150 User Reference Manual page 103

Cod
Function
e
202 System cache
206 Diskette drive
215 CD-ROM
217 Hard disk drive
Result
Aborted Test setup error: BIOS cannot access VPD information If your server does not
Test setup error: Corrupt DMI BIOS. Information in
BIOS is not as expected
Test setup error: No L2 cache detected on
microprocessor socket id xyz or BIOS setup problem
(where xyz identifies the microprocessor that is
causing the error message)
Test setup error: Unknown hardware problem
associated with microprocessor in socket id xyz.
(where xyz identifies the microprocessor that is
causing the error message)
Failed Microprocessor in socket ID xyz
(where xyz identifies the microprocessor that is
causing the error message)
Note: The indicated microprocessor LED will be
on.
Warning Test setup error: Cache is disabled. Use system setup
to enable before retrying the test
Failed Internal diskette drive bay
Aborted The CD-ROM drive is not present.
Failed On system board.
Failed BIOS drive # n (where n is the drive bay number)
Text message Action
have the latest level
BIOS installed, update
the BIOS to the latest
level and run the
diagnostic program
again.
If the problem persists,
call for service.
1. If your server does
not have the latest
level BIOS
installed, update
the BIOS to the
latest level
2. Run the diagnostic
program again.
3. If the problem
remains, replace the
failing processor.
If the problem persists,
call for service.
1. Reseat the
identified
microprocessor.
2. If the problem
remains, replace the
microprocessor.
If the problem persists,
call for service.
Use the Cache Control
choice from the
Advanced Setup menu
to enable the cache.
If the problem persists,
call for service.
Call for service.
Verify that the cables are
properly connected to
the CD-ROM. If the
problem persists, call for
service.
Call for service.
Call for service.
Chapter 4. Solving Problems
91