Table of Contents
Advertisement
Settings
Problem
The display is in a
language I cannot read.
I cannot turn on ECO
mode.
I cannot register a handset
to a base unit.
Battery charge
Problem
I fully charged the battery,
but the low battery
message is still displayed
and/or the operating time
seems to be shorter.
Calls
Problem
is displayed.
Cause and/or solution
R Change the display language (page 45).
R If [Repeater mode] is turned on (page 52), ECO mode is
automatically turned off and the [ECO mode] checkbox is not
displayed.
R The maximum number of handsets (6) is already registered to
the base unit. Cancel unused handset registrations from the
base unit (page 49).
R The maximum number of base units (4) is already registered to
the handset. Cancel unused base unit registrations from the
handset (page 51).
R You entered the wrong base unit PIN. If you forget your PIN,
contact an authorised service centre.
Cause and/or solution
R Clean the charge contacts of the handset and charger with a
dry cloth and charge again.
R It is time to replace the battery (page 3).
Cause and/or solution
R The handset is too far from the base unit. Move closer.
R The base unit's AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit. Register it
(page 49).
R During standby mode, the transmission range of the base unit
is reduced if ECO mode is on. If required, turn ECO mode off
(page 43).
Other Information
63
Advertisement
Table of Contents
