Table of Contents
Advertisement
9370_to make pdf_1ATT
TELEPHONE OPERATION
AT THE HANDSET
Changing Channels
This cordless telephone has an advanced AutoSelect feature that minimizes
the chance of interference. When the phone is looking for a clear channel,
the screen displays SEARCHING.... If it is unable to locate a clear channel,
the screen displays TRY AGAIN. Hang up and try your call again.
In the unlikely event that you notice noise or interference while using
the handset:
Press L.
1
2
If the interference does not clear, move closer to the base and
press L again until you find a clear channel (your call will
not be interrupted).
NOTE: You must be in range of the base to change channels (see the
OPERATING RANGE section of this manual).
Headset Jack
You can use this telephone hands-free when you install an AT&T 2.5 mm
headset (purchased separately).
1
Plug the headset into the jack located on the left side of the handset.
Do not force the connection, but make sure the plug fits securely.
2
Follow the instructions under "Make,Answer, or End a Call" on
page 19.
3
If you wish, attach the belt clip (see page 5 in the INSTALLATION
section of this manual).
NOTE: The earpiece and microphone on the handset are disabled when
the headset is plugged in.
22
6/12/00
2:07 PM
Page 22
L1
L2
Advertisement
Table of Contents
