Toshiba B-SX4 Series Key Operations Manual page 63

< 2 > P A R A M E T E R
D A T A L E N G .
[PAUSE]
< 2 > P A R A M E T E R
S T O P B I T
[PAUSE]
< 2 > P A R A M E T E R
P A R I T Y
[PAUSE]
< 2 > P A R A M E T E R
X O N + R E A D Y
[PAUSE]
< 2 > P A R A M E T E R
L C D
[PAUSE]
< 2 > P A R A M E T E R
F O R W A R D W A I T
[PAUSE]
< 2 > P A R A M E T E R
F W / B K A C T .
[PAUSE]
< 2 > P A R A M E T E R
H U C U T / R W D .
< 2 > P A R A M E T E R
S O L E N O I D
[PAUSE]
< 2 > P A R A M E T E R
R B N S A V E
[PAUSE]
S E T
8 b i t s
S E T
1 b i t
S E T
E V E N
S E T
A U T O
S E T
E N G L I S H
S E T
O F F
S E T
M O D E 1
S E T
O F F
[PAUSE]
S E T
T Y P E 2
S E T
O N ( T A G )
- 60 -
(13) Data length selection:
Select the data length using the [FEED]
and [RESTART] keys.
(14) Press the [PAUSE] key.
(15) Stop bit length setting:
Select the stop bit length using the
[FEED] and [RESTART] keys.
(16) Press the [PAUSE] key.
(17) Parity setting:
Select the parity using the [FEED] and
[RESTART] keys.
(18) Press the [PAUSE] key.
(19) Transmission control method selection:
Select the transmission control method using
the [FEED] and [RESTART] keys.
(20) Press the [PAUSE] key.
(21) Language selection for LCD messages:
(21) Language selection for LCD messages:
Select the language for LCD messages Select the language for LCD messages
using the [FEED] and [RESTART] keys.
using the [FEED] and [RESTART] keys.
(22) Press the [PAUSE] key.
(23) Setting for forward feed standby:
Make the forward feed standby setting using
the [FEED] and [RESTART] keys.
(24) Press the [PAUSE] key.
(25) Setting for forward feed standby action:
When the forward feed standby is set to ON,
select the action of the forward feed standby
using the [FEED] and [RESTART] keys.
(26) Press the [PAUSE] key.
(27) Setting for head-up operation in cut issue
(24) Press the [PAUSE] key.
mode:
Make the head-up operation setting or the
(15) Stop bit length selection:
rewinder use setting using the [FEED] and
Select the stop bit length using the
[RESTART] keys.
[FEED] and [RESTART] keys.
(28) Press the [PAUSE] key.
(29) Installed solenoid type setting:
(26) Press the [PAUSE] key. Set which type of solenoid is installed,
TYPE 1 or TYPE 2, with the [FEED]
and [RESTART] keys.
(30) Press the [PAUSE] key.
(31) Ribbon saving system setting:
Determine whether or not the ribbon
saving system is used with the [FEED]
and [RESTART] keys.
(32) Press the [PAUSE] key.