Toshiba B-SX4 Series Key Operations Manual page 30

(5) The printer feeds about 160 mm long media to detect a black mark/gap and determine the
threshold. When the printer detects more than two black marks/gaps during this 160-mm media
feed, the printer measures the media pitch and stops the automatic calibration 1 mm short of the
bottom of a black mark or gap.
(6) If the second black mark/gap is not found under the above conditions, the printer continues
media feed for up to 500.0 mm until the second black mark/gap is found. If it still cannot be
detected, the printer will stop, resulting in a paper jam.
(7) This function is available only when the media pitch is 10.0 mm to 150.0 mm.
(8) When the cutter is installed and a previous issue was performed in cut issue mode, the media is
cut and ejected after an automatic calibration completes.
(9) When the automatic calibration is in operation, labels do not stop at a strip position even in strip
or special strip mode.
(10) When a label end or a head open error occurs during an automatic calibration, the printer stops,
resulting in an error. Closing the print head can clear the error and resume the automatic
calibration.
(11) During an automatic calibration, the ribbon motors are rotated. Even if the ribbon is not loaded,
this function does not result in an error. However, the print condition will be automatically
changed to "No ribbon" after the calibration ends.
- 27 -