Adjusting Initial Settings; Setting The Clock; Switching The Warning Tone; Switching The Auxiliary Setting - Pioneer DEH-P3000IB Operation Manual

Section
(_I_n_it_ia_I_S_e_tt __ i _ n--=--g_s
~)
GIl
,
Adjusting initial settings
1 Press OFF and hold until the unit turns
off.
2 Press MULTI-CONTROL and hold until
CLOCK SET appears in the display.
3 Turn MULTI-CONTROL to select one of
the initial settings.
CLOCK SET (clock)--WARNING TONE (warn-
ing tone)-AUX1 (auxiliary input 1)-AUX2
(auxiliary input 2)-SW CONTROL (rear out-
put and subwoofer controller)-EVER SCROLL
(ever scroll)-BT AUDIO (Bluetooth audio)-
PIN CODE INPUT (pin code input)-
BT VER INFO (Bluetooth version information)
• You can also perform the same operations by
pushing MULTI-CONTROL up or down.
• You can also select the function by pressing
FUNalON on the remote control.
• To cancel initial settings, press BAND.
• BT AUDIO, PIN CODE INPUT and
BT VER INFO can be selected only when Blue-
tooth adapter (e.g., CD-BTB200) is connected to
this unit.e!]
Setting the Iclock
Use these instructions to set the clock.
1 Use MULTI-CONTROL to select
CLOCK SET.
2 Press MULTI-CONTROL to display the
setting mode.
• Press BACK to return to the previous display.
3 Press MULTI-CONTROL to select the seg-
ment of the clock display you wish to set.
Each time you press MULTI-CONTROL, one
segment of the clock display is selected.
Hour-Minute
As you select segments of the clock display,
the selected segment blinks.
4 Turn MULTI-CONTROL to put a clock
right.
• You can also perform the same operations by
pushing MULTI-CONTROL up or down. e!]
Switching the warning tone
If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone sounds. You can
turn off the warning tone.
1 Use MULTI-CONTROL to select
WARNING TONE.
2 Press MULTI-CONTROL to turn warning
tone on.
• To turn warning tone off, press
MULTI-CONTROL again. e!]
Switching the auxiliary setting
Auxiliary devices connected to this unit can be
activated individually. Set each AUX source to
ON when using. For more information about
connecting or using auxiliary devices, refer to
Using the AUX source on page 28.
1 Use MULTI-CONTROL to select AUX11
AUX2.
2 Press MULTI-CONTROL to turn AUX11
AUX2 on.
• To turn AUX off, press MULTI-CONTROL
again. e!]
En
·00