Adjusting Initial Settings - Pioneer Super Tuner III D DVH-P5000MP Operation Manual

Initial Settings

Adjusting initial settings

1
Initial settings lets you perform initial set up of
different settings for this unit.
1 Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press F and hold until function name
appears in the display.
3 Press F to select one of the initial set-
tings.
Press F repeatedly to switch between the fol-
lowing settings:
ClockWARN (warning tone)AUX (auxili-
ary setting)DIMMR (dimmer)R-SP (rear
output and subwoofer controller)TEL (tele-
phone muting/attenuation)A-PLY (auto
play)D_ATT (digital attenuation)
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down F until the unit turns off.
# When the multi-channel processor (e.g., DEQ-
P7000) is connected to this unit, you can operate
D_ATT instead of R-SP.
Setting the clock
Use these instructions to set the clock.
All manuals and user guides at all-guides.com
1 Press F to select clock.
Press F repeatedly until clock appears in the
display.
2 Press m or n to select the segment
of the clock display you wish to set.
Pressing m or n will select one segment
of the clock display:
HourMinute
As you select segments of the clock display
the segment selected will blink.
3 Press r or q to set the clock.
Pressing r will increase the selected hour or
minute. Pressing q will decrease the se-
lected hour or minute.
Switching the warning tone
If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
1 Press F to select WARN.
Press F repeatedly until WARN appears in the
display.
2 Press r to turn warning tone on.
WARN :ON appears in the display.
# To turn warning tone off, press q.
Section
14
75
En