Pioneer DEH-P3000IB Operation Manual page 56

C~I n_s_t_al_la_t_io_n ~)
DIN Rear-mount
1. Extend top and bottom of the trim
ring outwards to remove the trim
ring. When reattaching the trim ring,
push the trim ring onto the unit until
it clicks. (If the trim ring is attached
upside down, the trim ring will not
fit properly.)
• It becomes easy to remove the trim ring if the
front panel is released.
2. Determine the appropriate position
where the holes on the bracket and
the side of the unit match.
-~t f~
~o ,~@
o
3. Tighten two screws on each side.
• Use either truss screws (5 mm x 8 mm) or
flush surface screws (5 mm x 9 mm), depend-
ing on the shape of screw holes in the bracket.
~/
Screw
Factory radio mounting bracket
C~ E---"ng=--I_is~h
)
Fastening the front panel
If you do not plan to detach the front panel,
the front panel can be fastened with supplied
screw.