Table of Contents
Advertisement
Introduction
The Advantium ATC is an "Above The Cooktop" oven that has the functionality of a microwave, convection,
and speedcook oven. Five heat sources are available for cooking. Two 1200-watt halogen lights are located
at the top of the unit. A convection system, located behind the right-side of the oven cavity, provides a
1550-watt heat source and fan to circulate cavity air. A 500-watt ceramic heater provides additional heat
from the bottom of the oven. The Advantium can also be used as a 950-watt microwave oven.
The oven operates in one of eight modes:
• Idle - No cycles have been selected, unit is plugged in and idle.
• Speedcook - Used for faster cooking, all heat sources including microwave energy are used.
• Microwave - Functions as a standard microwave, cooks with microwave energy only.
• Convection - Uses only the convection element and air is circulated throughout the cavity.
• Broil - Uses all heat sources except microwave energy
• Toast - Operates similar to Broil.
• Warm - Used to keep items warm after they have been cooked.
• Proof - Provides correct temperature for proo¿ ng dough.
See the
section for Information pertaining to starting a cycle. See
for
Operating Modes
Load Algorithms
information pertaining to how the loads cycle during each mode.
Cooking modes are started by pressing a key on the key panel. When a selection has been made, a menu
appears on the display. The selector knob is then used to navigate. Rotating the knob allows scrolling menu
items and highlights each item. When the knob is pressed in, the highlighted item is selected. Press the start
key and the cycle starts.
When the cycle starts, the Smart Board sends 5 VDC to the appropriate relays on the Relay Board. The relay
then switches neutral to the load. Loads are operated according software algorithms (See
.)
Load Algorithms
contained in the Smart Board.
To troubleshoot the oven:
1 Determine in which mode of operation the failure is occurring.
2. Look at the
to determine what normal operation is.
Load Algorithm Chart
3. Determine which part is not functioning correctly.
4. Look up failing part in the table of contents.
5. Go to the appropriate page and ¿ nd the troubleshooting section for that part.
6. Follow troubleshooting instructions.
– 7 –
Hide quick links:
Advertisement
Table of Contents
