Table of Contents
Advertisement
C
•
Make sure that there are no residues of food or soil in or around the edge of the sump.
•
Put back in place the flat filter (C). Make sure that it is correctly positioned under the 2 guides.
•
Reassemble the filters (A) and (B).
•
Put back the filter (A) in the flat filter (C). Turn it clockwise until it locks.
An incorrect position of the filters can cause bad washing results and damage to the appliance
CLEANING THE SPRAY ARMS
Do not remove the spray arms. If the holes in the
spray arms are clogged, remove remaining parts of
soil with a thin pointed object.
EXTERNAL CLEANING
•
Clean the appliance with a moist soft cloth.
•
Only use neutral detergents.
•
Do not use abrasive products, abrasive cleaning
pads or solvents.
TROUBLESHOOTING
If the appliance does not start or it stops during
operation, before you contact the Service, check if
you can solve the problem by yourself with the help
of the information in the table.
Problem and alarm code
You cannot activate the appliance.
The programme does not start.
INTERNAL CLEANING
•
Carefully clean the appliance, including the
rubber gasket of the door, with a soft moist
cloth.
•
If you regularly use short duration programmes,
these can leave deposits of grease and
limescale inside the appliance. To prevent this,
we recommend to run long duration
programmes at least 2 times per month.
With some problems different indicators flash
intermittently and/or continuously to show an alarm
code.
Possible solution
•
Make sure that the mains plug is connected to the mains
socket.
•
Make sure that there is no a damage fuse in the fuse box.
•
Make sure that the appliance door is closed.
•
Press Start.
•
If the delay start is set, cancel the setting or wait for the
end of the countdown.
•
The appliance has started the procedure to recharge the
resin inside the water softener. The duration of the proce-
dure is approximately 5 minutes.
13
Advertisement
Table of Contents
