Loading Paper In The Interposer - Toshiba e-Studio 901 Operator's Manual

Loading Paper in the Interposer

The following procedure explains loading paper into the interposer.
Important
❒ Load paper on the side already printed (the front side). If you are using the
Booklet Finisher (Saddle Stitch), load sheets print side down.
❒ Load paper in the interposer in the same orientation as paper in the paper
tray.
❒ The staple or punching location will be on the left side of the paper, when you
are facing the machine.
❒ Do not place anything on top of or leave documents on the sensor. This may
lead to the paper size not being correctly scanned or paper jams.
❒ When using the Z-fold function, the paper in the interposer must be of the
same size as the prints after they have been Z-folded. If the paper in the inter-
poser is larger than the Z-folded sheets, a misfeed might occur.
A
While pressing the release lever, align the side fence with the paper size to
be loaded.
B
Load paper orderly. Tightly fit the side fence to the loaded paper.
C
When loading paper larger than A4, draw out the paper extender.
ANQ010S
ANQ012S
Loading paper
5
67