Loading Paper In The Interposer - Toshiba E-studio 1105 Operating Instructions Manual

5. Press the elevator switch on the multi bypass tray (Tray 7).
The green lamp of the elevator switch is blinking while the paper table is going up and down, and
keeps lit when it stops.
Press the elevator switch to move down the paper table if you want to either add paper or remove
jammed ones.
• The tray can hold up to 500 sheets.
• For details about using the multi bypass tray (Tray 7), see "Using the Multi Bypass Tray (Tray 7)",
Copy and Document Server Reference

Loading Paper in the Interposer

This section describes how to load paper into the interposer.
• Load paper on the side already printed (the front side). If you are using the Booklet Finisher SR5020,
load sheets print side down.
• Load paper in the interposer in the same orientation as paper in the paper tray.
• The staple or punching location will be on the left side of the paper, when you are facing the machine.
• Do not place anything on top of or leave documents on the sensor. This may lead to the paper size
not being correctly scanned or paper jams.
• When using the folding functions, the paper in the interposer must be of the same size as the prints
after they have been folded. If the paper in the interposer is larger than the folded sheets, a misfeed
might occur.
• Do not stack paper over the limit mark.
• Do not use paper that has already been printed onto by this machine.
BQX060S
.
Loading Paper
3
95