Table of Contents
Advertisement
Getting started
Battery installation & charging
After installing the battery, you may be able to make or receive short calls. For
best performance, place the handsets in the telephone base or charger to charge
for 16 hours before use.
You can keep the battery charged by returning the handsets to the telephone
base or the charger after use. When the battery is fully depleted, a recharge takes
about 12 hours. The average talk time on a fully charged battery is about five
hours, and the standby time is approximately six days. Actual battery life depends
on usage conditions and age of battery.
1. Plug the small end of
the smaller power adapter
into the jack on the under-
side of the charger, then
route the cord through the
slot as shown.
6. You may be able to make or receive
short calls. For best performance, place
the handset in the telephone base or
charger to charge for at least 16 hours
before first use.
Battery low indicator
Return the handset to the
telephone base or charger to
recharge when this symbol
flashes and the handset beeps
or when the handset screen
displays NEEDS RECHARGING.
Caution: Use only the supplied rechargeable battery, replacement battery 2422 (SKU 23402, part
number 89-0047-00-00) or equivalent.
website at www.telephones.att.com or call 1 (800) 222-3111. In
Canada dial 1 (866) 288-4268.
2. Plug the large
end of the smaller
power adapter into
an electrical outlet
not controlled by a
wall switch.
3. Insert the plug as indicat-
ed. Be sure to securely insert
the plug, making sure that it
matches the color-coded label
inside the battery compartment.
BATTERY LOW
-- 1 --
then
10:08
02/14
AM
To order a replacement battery, visit our
NEEDS RECHARGING
NOTE: Under normal conditions, the
battery should last around one year. This
may vary depending on usage.
7
4. Place the bat-
5. Slide the bat-
tery and wires
tery compart-
inside the com-
ment cover up
partment.
until it clicks.
To replace the battery,
press in and downward
on the tab of the bat-
tery compartment to
open the battery com-
partment cover. Lift
out the old battery
and disconnect it from
the handset. Follow
the instructions on
this page to install and
charge the new battery.
Advertisement
Table of Contents
