AT&T 91-001105-040-100 User Manual page 9

Getting started
Telephone base installation
1.
Plug the small end of
the larger power adapter
into the power jack at
the bottom of the tele-
phone base.
5.
Plug the other end
of the telephone line
cord into a telephone
jack.
DSL filter
(Optional for DSL users,
see number four in the
note section, below.)
NOTES:
1. Use only the power adapter supplied with this product or equivalent.
ment power adapter, visit our website at www.telephones.att.com
or call 1 (800) 222-3111. In Canada dial 1 (866) 288-4268.
2. Be sure to use an electrical outlet not controlled by a wall switch.
3. This power adapter is intended to be correctly oriented in a vertical or floor mount position.
4. If you receive high speed internet through your telephone line (commonly referred to as DSL), and
you are experiencing interference during telephone conversations and/or your caller ID features
are not functioning properly, install a DSL filter to the telephone line between the telephone base
and the telephone wall jack. Contact your DSL service provider for a DSL filter.
Telephone line cord
6
2.
Plug one end of the
telephone line cord into
the telephone jack at the
bot tom of the telephone
base.
3.
Route cords through
slots.
4.
Plug the large end of
the larger power adapter
into an electrical outlet
not controlled by a wall
switch.
To order a replace-