8. Setting of the two-dimensional bar code reader
・Insert the Two-dimensional bar code reader into
the USB terminal.
・Read the bar codes shown below.
・Open "Device Manager" and check the setting of port.
Click the right button of the mouse for "My Computer". Then, select the items in the following order: [Properties]
→ [Hardware] → [Device Manager].
Note:The setting of port is changed according to the environment of the personal computer.
Example: Port is set to "COM4"
Additional page
Reference:
If you perform masking with the
sheet which is attached to the two-
dimensional bar code reader, you
can prevent an reading error.
The COM number is changed
according to the personal
computer environment.
- A20 ・L15 -
INC
VMA10003-R.3727.A
October.16.2007