Table of Contents
Advertisement
Fill Fuel Tank
The engine runs on No. 2 diesel fuel. Fuel tank capacity
is approximately 6.0 gallons (22.7 L).
1. Clean area around fuel tank cap.
2. Remove fuel tank cap.
3. Fill tank to about one inch below the top of tank, (bot-
tom of the filler neck). Do not overfill. Install cap.
4. Wipe up any fuel that may have spilled to prevent a
fire hazard.
Bleed Fuel System
1. Position machine on a level surface. Make sure fuel
tank is at least half full.
2. Press primer button on top of fuel filter until resis-
tance is felt.
Note: It may be necessary to operate the primer but-
ton up to 30 times or more after starting the engine.
3. Start engine and continue to operate primer button
until engine runs smooth.
Check Cooling System
The cooling system is filled with a 50/50 solution of water
and ethylene glycol antifreeze. Check level of the cool-
ant at the beginning of each day before starting the en-
gine. Capacity of cooling system is approximately 3.6
qts. (3.4 L).
CAUTION
If engine has been running, pressurized hot cool-
ant can escape when the radiator cap is removed
and may cause burns.
1. Park machine on a level surface.
2. Check coolant level. Coolant should be between
lines on the reserve tank when engine is cold.
3. Install reserve tank cap.
Greensmaster 3250−D
2
3
1. Fuel filter
2. Priming pump
4. If the coolant level is low, remove reserve tank cap
and add a 50/50 mixture of water and permanent ethyl-
ene glycol antifreeze. Do not overfill.
Page 3 − 5
1
Figure 3
1. Fuel cap
1
Figure 4
3. Drain Plug
1
Figure 5
1. Reserve tank
Engine
Advertisement
Chapters
Table of Contents
Troubleshooting
