Mitsubishi Electric MR-J3-T Quick Start Manual page 10

Preparations
Required for positioning control via a CC-Link network:
b Q-Rack with PLC and the CC-Link module QJ61BT11N
or
A–Rack with PLC and CC-Link module A1SJ61BT11, A1SJ61QBT11 or FX2N-16CCL-M
b CC-Link cable compatible with version V1.10 Standard
b Cable for connecting the PC/notebook to the PLC CPU:
Q series: SC-Q QC30R2
A and FX series: SC-09
b The GX IEC Developer programming software package for configuration of the data com-
munications settings
NOTE This Quick Start Manual describes the installation and setup of a typical servo system con-
sisting of an MR-J3-10T servo amplifier (single-phase, 230V / 100W) and an HF-KP13 ser-
vo motor. Note that the specifications of this sample system may differ from those of your
configuration – please check your equipment's instruction manuals for details if necessary.
1 - 2
Introduction
MITSUBISHI ELECTRIC