Monessen Hearth BDV300 Instruction Manual page 38

BDV Series Direct Vent Gas Fireplace
7. Secure the AC box to the control box using
screw provided. Figure 56
8. Plug in wiring harness to the back of AC box.
9. Connect the blower according to the wiring
diagram. Figure 57 Note: Be sure to use the
wires marked 'Blower'.
10. Replace glass frame .
11. Plug the AC box plug to the junction box. Fig-
ure 57
1. To test blower operation. Turn the fireplace
on. Turn blower on. The blower should turn on
within five (5) minutes. Refer to the operating
instructions on Signature Command remote
control for complete operation instructions.
Finishing
Re-install the lower access panel.
To Junction Box
In Fireplace
Blower
(300 W
Max)
the black and white wires on the Ac box
wiring harness are marked 'Blower', 'light'
and 'Aux'. It is important to use the wires
marked 'Blower' or the contoll will not work
correctly.
electrical Grounding Instructions: this
appliance is equipped with a three-prong
(grounding) plug for your protection against
shock hazard and should be plugged
directly into a properly grounded three-
prong receptacle.
38
Optional
{
WHITE
Light
BLACK
WHITE
BLACK
{ BLACK
Optional
WHITE
AUX
Figure 57 -
Blower Wiring Diagram
FP2103
AC fan wiring
optIoNAl FAN BloWeR systeM
Screw
Ac Box
Connector Hole
Figure 56 -
Connect AC Box to Control Box
FP1916
AC box
8/08
GREEN
Connector
Pin To Contro l Box
control Box
electrical connections should only be
performed by a qualified licensed electrician.
Main power supply must be turned off before
connecting the fan to the main electrical
power supply or performing service.
Connector Pin
Guiding Block
control Box
optional
Ac Box
FP103
54D0700