Star Wheel Holder - Brother DCP6690CW Service Manual

Star wheel holder

(12) Remove two CR frame springs from the CR support chassis.
(13) Remove the link gear holder LT ASSY* from the engine unit by removing the screw. Take
care not to drop the gear 15 from the link gear holder LT ASSY*.
(14) Lift up the CR support chassis.
(15) While lightly pressing down the two bosses that fit in the oval holes provided in the CR
support chassis, slide the star wheel holder to the front to release the small tabs from the
square holes of the CR support chassis and remove it.
Idle pulley
CR frame spring
CR guide rail
CR support chassis
Vertical loop end
Boss
Paper ejection roller
6-86
* Link gear holder LT DX ASSY on duplex print models
Square holes
Boss
(Front)
CR frame spring
Taptite, cup B
M3x10
Star wheel holder
Small tabs
Gear 15
Link gear holder LT ASSY*
(6_72_1)
Confidential