Setup Menu; Tv Pause; Perfectcolor™ (Manual Color Balance) - Mitsubishi Electric WD-52825 Owner's Manual

Setup Menu

Setup Menu

Figure 8
Figure 8. Setup Menu, NetCommand Option
Language
Display the on-screen menus in either English or
Spanish (Español). The first time you powered On your
TV, you were requested to select an on-screen menu
language. If you choose to change the selection, all
menu text will immediately switch to the language of
your choice.
Program titles and other information sent by a
broadcaster will be shown in the original language.
Color Balance
Your Mitsubishi TV uses six colors (Magenta, Red, Yellow,
Green, Cyan and Blue) to create color balance. You may
adjust the intensity of the colors automatically or manually
(PerfectColor™) or reset them to the default settings.
Each TV input or device has a memory for PerfectColor.
Auto (Color Balance)
If the Auto box is checked, your TV will optimize color
automatically and continuously. Both PerfectColor and
Reset options for Color Balance are grayed out and
unavailable.
PerfectColor™ (Manual Color Balance)
Figure 9
The PerfectColor (manual) option is only available when
Auto (Color Balance) is not checked. Select PerfectColor
and press ENTER to display the menu. Individual sliders
for Magenta, Red, Yellow, Green, Cyan and Blue will be
displayed. The sliders have a numeric value, where 63
is the maximum. The default setting for each color is 31
(center). Highlighted text will show which slider you are
adjusting. Each active input can be individually adjusted.
Press ADJUST or to navigate between colors
and ADJUST or to change the color slider
settings.
Figure 9. PerfectColor Menu, Manual Color Correction
Reset
Select to reset the Color Balance settings. Each active
input can be individually reset, if Auto is not checked.

TV Pause

TV Pause is a special feature of the internal TV Disc
personal video recorder (PVR). TV Pause is available
for CableCARD™, Ant-1, Ant-2, IEEE 1394 input and
tuning devices (cable boxes or satellite receivers
connected to Inputs 1,2 or 3).
This feature allows you to press PAUSE to "pause"
live TV. You can then search backwards or forwards
through the current TV program. When you pause
the TV program, an on-screen slider will show
approximately how far and in which direction(s) you
can search.
TV Pause has three settings:
• On Request: TV Pause is in the standby mode
until you press PAUSE for the first time after turning
on the TV, or after a channel or device change.
There will be a few seconds delay before a paused
picture appears. During this pause, you will not be
able to scan or skip backwards in the TV Program.
Later uses of TV Pause while in the same program,
will allow reverse scan or skip of the available TV
program as shown on the slider. The TV Pause
will return to the standby mode automatically when
you change the channel or device. The PIP/POP
features are available only when TV Pause is in the
standby mode and not enabled.
65