Mitsubishi Electric WD-52825 Owner's Manual page 46

Edit NetCommand®, Add Devices, continued
4. To test the learned command, press the ENTER
button on the TV remote while the learned function
is still highlighted. The device should perform the
selected function. The device needs to be turned
on and the IR emitters properly placed for the
test to be successful (see page 29 for IR emitter
placement). If the functions are not learned the first
time, try Learn again.
5. Repeat for each function to be learned.
6. To erase a learned function, highlight the check box
for that function and press CANCEL.
7. When the function signals have been learned,
press ADJUST to select Next> and move to the
[Device] Advanced Learn screen. NOTE: When
learning the device's remote control signals, point
the device's remote control at the TV screen.
Hint: If the device's remote control uses a single button
for both Power On and Power Off, don't learn the
Power Off function.
[Device] Advanced Learn Screen
Figure 17
After learning the basic device keys, the [Device]
Advanced Learn screen allows you to learn any special
keys for your device. Most common IR remote control
signal formats can be learned by NetCommand.
A table of specialized device keys is shown in
Appendix E. You only need to learn the functions your
devices respond to and can ignore the functions that
do not apply to your device.
Figure 17 [Device] Advanced Learn screen
46
Name Screen
Figure 18
The Name screen allows you to change the default
name for each device to a custom name of up to eight
characters (including a blank space), selecting from
letters, numbers and nine different characters. Press
ADJUST or to select each letter, then press
ENTER to move to the next position. Press CANCEL
on the remote to delete the current letter and move
back one character position. When in the first position,
the CANCEL button will return the name to the default
name.
Figure 18. Name screen
Connection for [Device] Screen
Figure 19
This screen allows the TV to learn the connection
between device(s) and input(s). Inputs 1-3,
Components 1 & 2, Input-DTV, VGA and/or the
inputs for the A/V Receiver all need to be checked, if
connected. Add or remove check marks to indicate
what type of connections (Audio, Video or both) are
used with each TV and A/V Receiver input.
Figure 19. Connection for [Device] screen