Quadra-Fire VOYA-GRAND-MBK Owner's Manual page 43

R
. urr u
Si e: 40 in. W 30 in.
u e i urr u i
ee e Powered 4 to 6 inches long Phillips head
1. Remove contents from bo being careful not to scratch or
damage the cast trim pieces.
Lay surround pieces face down on a protected surface to
2.
prevent scratching .
pieces. Secure the 3 pieces together.
the kit. Figure 3. .
5. n order to get a tight seal for the surround, you must reposition
a side shield. here are two holes on the shield and it will come
5. Position the trim on the appliance matching up the mounting
brackets with the slots on the appliance.
F .
4 Mounting Brackets
Figure 3.
Mounting
Brackets
Attach to Appliance
with Screws
Do not overtighten - may
damage porcelain finish
Figure 3.2
May 23, 2013
i
Remove and Reposition
Side Shield using Second
Hole
. er r
he blower cord is shipped to be installed on the right side
left side.
er ie
blower controls, re-routing the cord to the left side and re-
installing the power cord to the blower controls. Refer to
the e ploded drawing on
Figure 3.3
1. Swing the grille down to e pose the 2 bolts, one
at each end. Remove the bolts and pull blower
access assembly away from appliance and store
away from your work area.
Figure 3.
2. Remove the 2 screws in the hold down bracket in
remove the blower from the hold down bracket.
3. Disconnect the 2 blower wires that are attached
to the wire harness and pull the blower assembly
away from the appliance.
7075-166C
i e i e
ge .
Page 43
er