Mitsubishi WS-65315A Owner's Manual page 71

Terminal Cover Ventilation for Model WT-42315
At Least 2" (Inches) Away from Wall
Side Panel for Input Terminal
Included in the accessories bag is the side panel
to cover the input terminals, located on the bottom
right of your TV. See diagram. Follow the steps
below to attach or remove this side panel:
1. Remove the side panel from the accessories
plastic bag attached to the back of your TV.
2. Route all of the cable downward so the cover
can close over them.
3. Position the three tabs directly opposite the
three slots (see diagram) and gently push
toward the front of the TV.
4. Slide the two push tabs into the slots on the
other side of the terminals until both tabs snap
into place.
Result: The side panel neatly covers the input
jacks.
Reverse these steps to remove the side panel from
the input terminal.
Stand Requirement
CAUTION: This PTV for use only with Mitsubishi
stand MB-42413. Use with other stands may result
Wall
in instability causing possible injury.
Air Circulation Tip
When considering the location or position of your
TV, we recommend you place it at least 2" (inches)
away from the wall. Like most electrical equipment
and appliances, better air circulation allows your
television to run cooler, assuring a long, trouble-free
life.
Tabs
Slots
Side Panel
Slots for
Push Tabs
Push Tabs
71