EverFocus ECOR FHD 4F User Manual page 31

Set the Network Type to DHCP. Make sure to write down the IP address and the

Gateway.
Exit from the Menu to save settings.

To manually assign an address:
Go to a computer connected on the same network as the DVR.

Click on the Start button and choose Run.

If using Windows Vista, choose Search instead.
Type "command" and click on OK.

In Vista, you will need to double-click on the "Command Prompt" file to open it.
In the DOS prompt, type "ipconfig" and press Enter.

The network information will be displayed on a screen similar to the one below.

In Windows Vista, look for the information that says "IP v4".
Take the values for Subnet Mask and Default Gateway and input them into the DVR;

these values should be exactly the same in both devices. However, you should
change the last number of the IP address. For example, if the IP address of the
computer is 192.168.2.101, the DVR's IP address should be 192.168.2.50.
To access the DVR from a computer simply open Internet Explorer and in the address

bar type:
http:// (IP address of the DVR)
Note: The DVR's IP address will only work at the location of the DVR. To connect
from a different location over the Internet, see below.
ECOR FHD 4F / 8F / 16F Full HD DVR
23