Connecting The Attendant Control To The Electronics; Removing The Attendant Control From The Wheelchair - Invacare IDC User Manual

3.2 Connecting the attendant control to the
electronics
The intuitive attendant control takes over control of the
wheelchair and may only be used by an attendant. It is
imperative that the wheelchair driver himself is not allowed
to operate the attendant control.
Fitting should only be carried out by an Invacare® approved
dealer. When fitting, please ensure that the bus cable is
routed and fixed correctly so that damage to the bus cable
is avoided.
1. Switch the wheelchair electronics off at the master remote.
2. Connect one end of the bus cable to the IDC, the other end to a
free bus socket on the wheelchair.
In case there is no spare bus socket on the wheelchair's
control system, a splitter / 4–way bus socket can be ordered
from your Invacare® dealer.
3. The attendant control is now connected to the drive.
1521481-B
3.3 Removing the attendant control from the
wheelchair
1. Switch the wheelchair off, and dismantle the individual parts in
accordance with the instructions in the wheelchair's user manual.
2. Only ever pull the control unit plug out of its socket by holding
the housing, not the cable!
3.
Loosen the clamping lever (1) (rotates several times!) and pull
the control unit out of the wheelchair bracket.
Setup
7