Pole Mount - Electro-Voice ZxA1-90 Owner's Manual

Tripod and Floor Monitor Operation (cont')
Tripod
Electro-Voice ZxA1 speakers include 35mm (1-3/8 inch) stand mounts to allow mounting on tripod stands. Make sure to:
• Check the specifications of the speaker stand to be certain it is capable of supporting the weight of the speaker.
• Check that the speaker stand is placed on a flat, stable surface and be sure to fully extend the legs
of the stand. Do not try to make the stand "taller" and compromise its structural integrity.
• Route cables and position the stand so that performers, production crew and audience
members will not trip over the stand or cables and pull the speaker system over.
• Secure cables with wire ties or tape whenever possible.
• Do not attempt to suspend more than one speaker on a stand designed for a single speaker
• Unless you are confident that you can safely handle lifting the weight of the
speaker onto the stand, ask another person to help you place it.
• Tighten the set screw to minimize rattling and to prevent the speaker from rotating during use.

Pole Mount

Electro-Voice ZxA1-Sub speakers include 35mm (1-3/8 inch) pole mount cups to allow mounting a full range speaker above it.
Make sure to:
• Use a speaker pole that is no longer than 1.2m (4ft) and mount a speaker weighing no more than 11.3kg (25lbs).
• Check that the ZxA1-SUB is placed on a flat and stable surface.
Figure 2b:
ZxA1 on Tripod Stand
Electro-Voice ZxA1 Series Owner's Manual
Figure 2c:
ZxA1and ZxA1-Sub Full-Range/Sub Stack with Pole Mount
No more than
11.3kg (25lbs).
No longer than
1.2m (4ft).
7