Braun BP 6200 Instruction Manual page 8

Guidance and manufacturer's declaration – electromagnetic emissions
The ME equipment is intended for use in the electromagnetic environment specified below.
The customer or the user of the ME equipment should assure that it is used in such an environment.
Emissions Test Compliance Electromagnetic environment – guidance
The ME equipment uses RF energy only for it's internal
RF Emissions
Group 1 function. Therefore, its RF emissions are very low and are not
CISPR 11
likely to cause any interference in nearby electronic equipment.
RF Emissions
Class BF Complies
CISPR 11
Harmonic emissions
Not Applicable
IEC 61000-3-2
The ME equipment is solely battery powered.
Voltage fluctuations /
Not Applicable
flicker emissions
Non-Life Support Equipment Separation Distance Calculation
(3Vrms / 3V/m compliance)
Separation distance according to frequency of transmitter (m)
Rated maximum output
power of transmitter (W)
150 kHz to 80 MHz
in ISM bands
3.5
d=[ ]
P
V
1
0.01 0.12
3.5
d=[ ]
P
0.1 0.37
E
1
1 1.17
7
d=[ ]
P
10 3.69
E
1
100 11.67
14
3.5
d=[ ]
P
V
1
3.5
3.5
d=[ ]
P d=[ ]
P
V
E
1
1
80 MHz to
800 MHz to 2.5 GHz
800 MHz
7
3.5
d=[ ]
d=[ ]
P
P
E
E
1
1
0.12 0.23
7
d=[ ]
P
0.37 0.74
E
1
1.17 2.33
3.69 7.38
11.67 23.33
Guidance and manufacturer's declaration – electromagnetic immunity
The ME is intended for use in the electromagnetic environment specified below.
The customer or the user of the ME should assure that it is used in such an environment.
IEC60601 test
Immunity test
level
Electrostatic discharge
±6kV Contact
(ESD)
±8kV Air
IEC 61000-4-2
Radiated RF
3 V/m 80MHz to
2.5GHz
IEC 61000-4-3
Conducted RF
3Vrms 150kHz to
80MHz
IEC 61000-4-6
Electrical fast transient ±2kV power line
IEC 61000-4-4 ±1kV I/O lines
Surge ±1kV differential
IEC 61000-4-5 ±2kV common
Power frequency magnetic
field
3 A/m
IEC 61000-4-8
>95% dip 0.5
Voltage dips, short
cycle
interrupts and voltage
60% dip 5 cycles
variations on power
70% dip 25
supply input lines
cycles
IEC 61000-4-11
95% dip 5 sec.
Electromagnetic environment –
Compliance level
guidance
Floors should be wood,concrete, or
ceramic tile. If floors are covered with
Complies
synthetic material, the relative humidity
should be at least 30%.
Field strengths outside the shielded
location from fixed RF transmitters, as
Complies
determined by an electromagnetic site
survey, should be less than 3 V/m.
Interference may occur in the vicinity
of equipment marked with the follow-
ing symbol:
Not Applicable
Separation distance calculation
(no electrical
provided above. If a known transmitter
cabling)
is present the specific distance can be
calculated using the equations.
Not Applicable
The ME equipment is solely battery
powered.
Not Applicable
Power frequency magnetic fields
should be at levels characteristic of a
Complies
typical location in a typical commercial
or hospital environment.
The ME equipment is solely battery
Not Applicable
powered.
15