Labeling the IFL cable
Label the IFL cable at the outdoor point-of-entry and at the indoor location where
the satellite modem is installed as follows:
Wrap a piece of blue electrical tape around the cable, and mark SAT on the tape.
Hub or similar network device
The customer must supply and configure the network device, including required
cables, according to the device manufacturer's documentation. Required IP address
information is obtained during modem commissioning.
Instructions for related components
This installation guide covers only installation of the satellite modem. For
installation instructions for other components, see Table 2 on page 18.
You can view or download these documents at
Installer Login Click
contact your installer support for access to these documents
Safety (all components) Site survey, Site
preparation, Antenna mounts, IFL cable
IFL cables (specifications, approved
types, maximum lengths)
Antenna, antenna pointing, Radio
assembly
Here! on your installation support web site. If you cannot log in,
Table 2: Related installation documents
Component or topic
https://dwayinstalls.hns.com/.
Where to find instructions
Antenna Site Preparation and Mount
Installation Guide (1035678-0001)
HNS Broadband Requirements for RG-6
and RG-11 IFL Cable Connectors, Ground
Blocks, and Ground Block Location
(FSB_050518_01)
See the antenna installation guide for
the specific antenna model you are
installing.
For Ka-band antennas, see the Jupiter
Antenna Pointing Guide (1039429-0001)
Chapter 2 • Preparing for installation
1039649-0001 Revision C
Click
17