Removing And Installing - Mercedes-Benz 2016 Sprinter Operator's Manual

You must observe the correct wheel and
tire dimensions as well as the wheel type.
When using a spare wheel of a different size, do
not exceed the maximum speed of 80 km/h.
General notes
!
Check the spare wheel regularly to see that
it is secure and has the prescribed tire pres-
sure.
The procedure for mounting the spare wheel is
described in "Mounting a wheel" (
The following should be checked regularly, par-
ticularly prior to long journeys:
the tire pressure of the spare wheel, which
R
should then be corrected if necessary
( page 250).
Y
the fastenings of the spare wheel bracket.
R
The spare wheel is located in a spare wheel
bracket under the rear of the vehicle.
Replace the tires after 6 years at the latest,
regardless of wear. This also applies to the spare
wheel.
i
If you have mounted a spare wheel, the tire
pressure monitor (
Y
tion for this wheel. The spare wheel is not
equipped with a sensor for monitoring tire
pressure.
Removing and installing the spare
wheel
Cargo Van/Passenger Van
Bolt covers for the safety catches (example: Cargo
Van)
page 267).
Y
page 253) will not func-
Removing
Open the rear doors.
X
Place a screwdriver into recesses ; and then
X
pry off covers :.
Using the lug wrench from the vehicle tool kit
X
( page 240), unscrew the now visible bolts
Y
counter-clockwise by approximately 20 turns.
Spare wheel carrier under the vehicle
Slightly raise spare wheel bracket A and
X
unhook left-hand retaining hook =.
Assemble the pump lever for the jack and
X
slide it into sleeve ? on spare wheel bracket
A.
Raise spare wheel bracket A with the pump
X
lever and unhook right-hand retaining hook
=.
Slowly lower spare wheel bracket A down to
X
the ground.
Lift spare wheel bracket A slightly and pull
X
the pump lever out of sleeve ?.
Spare wheel in the spare wheel carrier
Spare wheel
273
Z