Setting The Time; Activating/Deactivating Highbeam Assist; Switching The Daytime Running Lamps On/Off - Mercedes-Benz 2016 Sprinter Operator's Manual

On-board computer (vehicles with steering wheel buttons)
164
Using the f, g, 4 or 9 adjustment buttons,
you can select the following functions:
Calling up the service due date
R
( page 226)
Y
Checking the oil level (
R
Checking the DEF supply (
R
Preselecting/setting the auxiliary heating
R
switch-on time (
Tire pressure monitor (
R

Setting the time (

R

Activating/deactivating Highbeam Assist

R
( page 171)
Y
Setting the daytime running lamps
R
( page 79)
Y
Setting the time
Turn the key to position 2 in the ignition lock.
X
Press the 4 menu button repeatedly until the
X
hours figure flashes.
Press the f or g button to set the hour.
X
Press the 9 reset button.
X
The minute display flashes.
Press the f or g button to set the minute.
X
i
If you keep the f or g button pressed, the
value will change continuously.
Activating/deactivating Highbeam
Assist
Turn the key to position 2 in the ignition lock.
X
Press the 4 menu button repeatedly until the
X
_ indicator lamp flashes and the
message appears in the display.
Use the f or g button to switch Highbeam
X
Assist on/off.
Switching the daytime running lamps
on/off
If you switch the daytime running lamps on, the
daytime running lamps will automatically light
up when the engine is running.
For safety reasons, it is only possible to change
this setting when the vehicle is stationary. The
factory setting is
time running lamp mode or daytime running
lamps are mandatory.
page 220)
Y
page 162)
Y
page 108)
Y
page 253)
Y
page 164)
Y
on
on in countries in which day-
Turn the key to position 2 in the ignition lock.
X
Press the 4 menu button repeatedly until the
X
L indicator lamp flashes and the
message appears in the display.
Press the f or g button to activate or deac-
X
tivate the daytime running lamps.
i
USA only:
If you turn the light switch to T or L,
the corresponding light switches on. If you
turn the light switch to Ã, the daytime
running lamps remain switched on.
Canada only:
If you turn the light switch to L, the low-
beam headlamps switch on. If you turn the
light switch to T or Ã, the daytime run-
ning lamps remain switched on.
On-board computer (vehicles with
steering wheel buttons)
Operating the on-board computer
Overview
or OFF
To activate the on-board computer: turn
X
the key to position 1 in the ignition lock.
The on-board computer shows vehicle informa-
tion and settings in the display.
You can control the display and the settings in
the on-board computer with the buttons on the
steering wheel.
on or OFF