Maintenance; Traveling And Transport - Ariens 921017 - Deluxe 24 Platinum Owner's/Operator's Manual

SNOW REMOVAL
IMPORTANT: Allow unit and engine to adjust
to the outdoor temperature before clearing
snow.
NOTE: Attachment clutch should be engaged
before traction drive clutch when throwing
snow.
1. Select Speed Control position and
direction.
2. Engage Attachment Clutch – Right Hand
Lever.
3. Engage Traction Drive Clutch – Left
Hand Lever.
IMPORTANT: DO NOT overload unit capacity
by attempting to clear snow at too fast a rate.
Use slow speed to clear deep or hard packed
snow.
Tips for Operation
Snow is best removed as soon as possible
after snow fall.
To clear an area, run unit in an overlapping
series of paths. For large areas, start in the
middle and throw snow to each side, so snow
is not cleared more than once.
ALWAYS direct snow away from area to be
cleared and with direction of the wind.
Ariens Dealers will provide any service or
adjustments which may be required to keep
your unit operating at peak efficiency. Should
engine service be required, contact an Ariens
dealer or an authorized engine
manufacturer's service center.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
SERVICE POSITION
(Figure 23)
WARNING: Before tipping unit up
onto housing, remove fuel so no
spills will occur. Ensure unit is
secure and will not tip over during

maintenance.

1. Shut off engine, remove key, disconnect
spark plug wire and allow unit to cool
completely.
2. Close fuel shut-off valve (see Fuel Shut-
Off Valve on page 21).
3. Drain fuel tank and fuel system (see
Engine Manual for complete
instructions).
4. Place unit on a flat level surface. Tip unit
forward onto front of auger housing for
service.
TRAVELING
To travel from one work area to another:
1. Set Throttle to Slow or Part-Throttle
2. 921013, 017, 018, 022, 027, 031, 034:
3. Engage traction drive clutch lever
TRANSPORT
ALWAYS shut off engine, remove key, and
close fuel shut-off valve when transporting
unit on a truck or trailer.
Use extra care when loading or unloading
unit onto trailer or truck.
Secure unit chassis to transport vehicle.
NEVER secure from rods or linkages that
could be damaged.
DO NOT transport machine while engine is
running.
MAINTENANCE
IMPORTANT: Ensure unit is secure and will
not tip over. Strap and clamp onto bench if
needed.
EN - 23
position.
Press down on handlebars enough to
raise front of unit slightly off surface.
921023: Place the unit in the transport
position (see Track Angle on page 20).
without engaging attachment drive
clutch.
Service Position
Figure 23