Check Tire Pressure - Ariens 921017 - Deluxe 24 Platinum Owner's/Operator's Manual

Remote Deflector Control
(Figure 14)
NOTE: Connect the barrel cable end to the
chute deflector cable anchor before clipping
the cable to the discharge chute cable
bracket.
1. Route deflector cable along the left side
of the chute pedestal.
2. Insert the barrel cable end into the
bracket on left side of chute deflector
(Figure 14).
3. Hold seal out of the way while routing
the cable through the bracket on the left
side of the discharge chute, and then
push the cable fitting into the bracket.
4. Push the seal securely over the end of
the cable fitting to prevent water from
entering the cable.
5. Check deflector travel. Adjust nut on
cable end under control panel to obtain
full travel, if necessary (see Remote
Deflector Control Adjustment on
page 27).
.
2
1
5
4
1. Chute Deflector Cable Anchor
2. Barrel Cable End
3. Deflector Cable
4. Cable Fitting
5. Discharge Chute Cable Bracket
Figure 14
Install Skid Shoes (921013, 018)
(Figure 15)
NOTE:
1. Remove hardware from skid shoes.
2. Install hardware through blower housing
and skid shoe as shown.
3. Adjust skid shoes (see Skid Shoes on
page 26).
3
3
1
2
3
4
1. Bolt, Round Head Square Neck
.38-16 x 1.00
2. Skid Shoe, Reversible
3. Washer, Flat Steel
.438 x 1.00 x .083
4. Nut, Locking, Center, .38-16
Check Function of Dual Handle
Interlock
Without the engine running, press down
(engage) both clutch levers. Release
attachment clutch lever. Attachment clutch
should remain engaged until traction clutch
lever is released, then both clutches must
disengage. If they do not, contact your Dealer
for repairs.

Check Tire Pressure

(921013, 017, 018, 022, 027, 031, 034)
Check tire pressure and adjust to the
pressure listed on tire sidewall.
CAUTION: Avoid injury! Explosive
separation of tire and rim parts is
possible when they are serviced
incorrectly:
• Do not attempt to mount a tire
without the proper equipment and
experience to perform the job.
• Do not inflate the tires above the
recommended pressure.
• Do not weld or heat a wheel and
tire assembly. Heat can cause an
increase in air pressure resulting
in an explosion. Welding can
structurally weaken or deform the
wheel.
• Do not stand in front or over the
tire assembly when inflating. Use a
clip-on chuck and extension hose
long enough to allow you to stand
to one side.
EN - 13
Figure 15