Placement Of Speakers; Making The Connections - Panasonic CS-PMX100 Operating Instructions Manual

Placement of speakers

Place the speakers so that the tweeter is on the inner
side. To prevent damage to the speakers, do not touch
the speaker cones if you remove the nets.
Use only the supplied speakers.
The combination of the main unit and speakers give the
best sound. You can cause damage to the system and
decrease the sound quality if you use other speakers.
Note:
• Keep your speakers more than 10 mm from the main unit
for ventilation.
• Put the speakers on a flat safe surface.
• These speakers do not have magnetic shielding. Do not
put them near TVs, PCs or other equipment easily
influenced by magnetism.
• When you play at high levels for a long period, it can cause
damage to the system and decrease the life of the system.
• Decrease the volume in these conditions to prevent
damage:
- When you play distorted sound.
- When you adjust the sound quality.
CAUTION!
• Use the speakers only with the recommended
system. If not, you can cause damage to the
amplifier and speakers and can cause a fire.
Consult an approved service personnel if damage
occurs or if there is a sudden apparent change in
performance.
• Do the procedures included in these instructions
when you attach the speakers.
4

Making the connections

Connect the AC mains lead only after all the other
Tweeter
connections have been made.
[PMX100]
3 3
[PMX100B]
3 3
1
Connect the antenna.
Place the antenna where reception is best.
• If radio reception is poor, use an outdoor antenna
(not supplied).
[PMX100]
[PMX100B]
2 2
1 1
To household mains socket
2 2
1 1
To household mains socket
Tape
(not supplied)
Tape
(not supplied)
Be sure to fully tighten
the nut.
2
Connect the speakers.
i: Red line
Main unit (rear)
j: Copper
To right speaker
(rear)
Be careful not to cross (short-circuit) or reverse
the polarity of the speaker wires as doing so may
damage the speakers.
3
Connect the AC mains lead.
Do not use an AC mains lead with other equipment.
Conserving power
The system consumes a small amount of power (
even when it is in standby mode. Disconnect the power
supply if you do not use the system.
Some settings will be lost after you disconnect the
system. You have to set them again.
Connecting other equipment
You can connect a VCR, DVD player etc.
Main unit (rear)
Audio cable (not supplied)
Note:
• Disconnect the AC mains lead before connection.
• Switch off all equipment and read the appropriate operating
instructions.
• Components and cables are sold separately.
• If you want to connect equipment other than those
described, refer to the audio dealer.
• Sound distortion can occur when you use an adaptor.
Left speaker (rear)
21),
e.g. DVD player
(not supplied)