Starter Relay Switch Power Input Line; Starter Relay Switch Function Inspection - Honda 2004 CRF250X Service Manual

ELECTRIC STARTER
18-12
POWER INPUT LINE
Connect the starter relay switch 4P connector.
Shift the transmission into neulral.
Pull the clutch lever fully, and push the starter
switch .
Measure the vol tage between the Yellow/red wire
terminal (+) and ground H .
If the battery voltage appears only when the starter
switch is pushed, the circu it is normal.
FUNCTION INSPECTION
Disconnect the battery negative H cable from the
battery.
Remove the starter relay switch from the rubber
case.
Remove the terminal bolts and disconnect the
starter relay switch cables.
Remove the 4P connector from the starter relay
switch.
Connect an ohmmeter to the starter relay switch
cable terminals.
Connect the fully charged 12 V battery positive ter-
minal to the Yellow/red w ire terminal and negative
terminal to the Green wire terminal of the starter
relay switch.
There shou ld be continui ty between the cable termi-
nals while the battery is connected, and no continu-
ity when the battery is disconnected.
Install the st arter relay switch in the reverse order of
removal.
BATIERY
STARTER RELAY SWITCH
,